Deye SUN-5K-SG03LP1-EU Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Инвертор Deye SUN-5K-SG03LP1-EU. Deye SUN-5K-SG03LP1-EU 19 страниц. Hybrid inverter

Current transformer (Optional)

Battery sensor

L-type Hexagon wrench

Wall mounting bracket

Chart 3-1 Parts List

3.2 Mounting instructions

Installation Precaution

This Hybrid inverter is designed for outdoor use(IP65),Please make sure the installation

site meets below conditions:

・ Not in direct sunlight

・ Not in areas where highly flammable materials are stored.

・ Not in potential explosive areas.

・ Not in the cool air directly.

・ Not near the television Antenna or antenna cable.

・ Not higher than altitude of about 2000 meters above sea level.

・ Not in environment of precipitation or humidity(>95%)

Please AVOID direct sunlight, rain exposure, snow laying up during installation and

operation. Before connecting all wires,please take off the metal cover by removing

screws as shown below:

Considering the following points before selecting where to install:

・ Please select a vertical wall with load-bearing capacity for installation, suitable for

installation on concrete or other non-flammable surfaces,installation is shown below.

・ Install this inverter at eye level in order to allow the LCD display to be read at all times.

- 05 -

・ The ambient temperature should be between -25~60℃ to ensure optimal operation.

・ Be sure to keep other objects and surfaces as shown in the diagram to guarantee

sufficient heat dissipation and have enough space for removing wires.

For proper air circulation to dissipate heat, allow a clearance of approx. 50cm to the side

and approx.50cm above and below the unit.And 100cm to the front.

Mounting the inverter

Inverter should vertically installed, as shown，installation procedure show below:

1. Position the bolts on the appropriate wall according to the bolt positions on the

mounting shelves and mark the holes. On the brick wall, the installation must be

suitable for the expansion bolt installation.

2.Ensure that the position of the installation holes on the wall (A, B, C, D) are the same

position of the install plate, and the mounting level is guaranteed.

3. Hang the inverter to the top of the mounting rack and then use the M4 screw in the

accessory to lock E and F to ensure that the inverter does not move.

≥500mm

- 06 -