COZY VC201A-H and Руководство по установке и эксплуатации - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Газовый обогреватель COZY VC201A-H and. COZY VC201A-H and 18 страниц. Gas-fired vented room heater
Также для COZY VC201A-H and: Руководство по установке и эксплуатации (18 страниц), Руководство по установке и эксплуатации (19 страниц)

TSK WALL STAT KIT

WALL THERMOSTAT INSTALLATION INSTRUCTIONS

This kit must be installed by a qualified installer or service technician.

Your heater can be re-wired to operate with a millivolt wall thermostat by your installer. See wiring diagram

below for correct wiring.

NOTE: Do not disconnect the wire from the blocked flue switch to the "TH" terminal on the gas valve.

STEP 1.

Turn temperature control knob to "OFF" or lowest setting.

STEP 2.

Turn gas valve control knob to "OFF".

STEP 3.

Disconnect wire leading from Part #70080 (Bulb Control Switch) from valve.

STEP 4.

Cut the remaining wire leading from Part #70080 (Bulb Control Switch) to the blocked flue

switch, leaving its end connected to the blocked flue switch and leaving enough length to reach

the gas valve. Strip 1/2" of the insulation from the cut end of the wire.

STEP 5.

Connect one leg of thermostat wire to the "TH/PP" terminal on the gas valve.

STEP 6.

Connect second leg from the thermostat to the stripped wire coming from the blocked flue

switch. Secure this connection inside the heater cabinet.

STEP 7.

Secure both red wires from blocked flue switch inside heater cabinet. Make sure none of the

wires have enough slack to lay against the heat exchanger or draft hood.

STEP 8.

Remove lighting instructions P/N 91237, 91238, 91239 from back of heater and replace with

P/N 91242, 91243, 91244 lighting instructions supplied in TSK Kit.

STEP 9.

Follow lighting instructions to place heater in operation.

BLOCKED

FLUE SWITCH

JULY 2005

(VC/VCR-H SERIES HEATERS)

THERMOSTAT

(OPTIONAL)

WIRE

NUT

(Not provided)

OPTIONAL

Page 14

PILOT

GENERATOR