Avocet 45tt Руководство - Страница 11

Просмотреть онлайн или скачать pdf Руководство для Циклометр Avocet 45tt. Avocet 45tt 13 страниц.

PART V–INSTALLATION–FRONT MOUNT

1. TRANSMITTER.

Remove the front wheel. Count the number of spokes in the wheel.

Use the 4- prong transmitter for 32-spoke wheels, and the 3-prong transmitter for 36 or 28-spoke

wheels. If necessary remove the magnet and metal ring from one housing and move it to the

other. Keep the strong side of the magnet facing out as originally installed. The transmitter snaps

on the flange of a standard, low-flange hub. After attaching the transmitter reinstall the wheel.

You can also attach the front transmitter with ties if your hub flange is too large or small for it to

snap on. Cut off the transmitter prongs with scissors, then attach it to the spoke crossings.

Use the 4-prong transmitter

for 32-spoke wheels

Transmitter

Hub flange

SNAP-ON

METHOD

Prong

Use the 3-prong transmitter

for 36- & 28-spoke wheels

Spoke

crossing

Tie

CABLE TIE

METHOD

2a. MOUNTAIN RECEIVER.

Fits any fork. If you have a suspension fork or a mountain

bike fork with fat blades that taper for the slotted ends, use the mountain receiver. Clean and dry

the front of the right fork blade. Slide the receiver into its holder (wires on the inside). Loosen the

pivot screw and install the fork pad loosely on the front of the right fork blade with two cable ties

inserted through the holes in the pad. Pivot and rotate the receiver until it touches the transmitter

magnet. Tighten the pivot screw with the receiver against the front of the fork. Tighten and trim

the cable ties, and fine-tune the adjustment by sliding the receiver in its holder until it nearly

touches the transmitter.

Fork pad

Pivot

Holder

Receiver

Use the mountain receiver

on fat mountain bike forks

Pivot the holder until it

Some forks may require

touches the fork

reversing the holder