Billi Quadra Руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Руководство пользователя для Кухня и аксессуары; светильники для ванной Billi Quadra. Billi Quadra 12 страниц. Xl, xt, xr tap options
Также для Billi Quadra: Руководство пользователя (13 страниц), Руководство по установке (8 страниц), Руководство по установке (7 страниц)

User guide

Billi Quadra & Quadra Plus.

Filter removal and

replacement instructions

Important note: Please ensure you remove the

foam packing under the filter before installing .

1 . Press or hold the "ON/OFF" Button until

the lights in the tap turn OFF .

2 . Hold filter and pull towards you slowly .

The top of the filter is in a hinged cradle

assembly . It should stop after approximately

30 degrees of travel .

3 . The filter can now be released from the

holding cradle by pulling down on the filter .

4 . Take care not to spill water in the base of

the tray . If so wipe gently with absorbent

paper towel .

5 . Install new filter(s) into the same location

by pushing all the way up into the cradle .

6 . Push filter(s) forward until perpendicular

to the base and locked in place .

7 . Unit will now begin an automatic flush cycle .

Tap lights will flash orange and water will

dispense from the cold side of the tap .

8 . When the flush cycles finishes, the unit

will automatically reset and return to the

previous operating mode . It is normal to

see the tap lights displaying a solid red light

and a flashing blue light . This indicates that

the chilled water is currently being chilled

and should return to a solid blue light

within 5 minutes .

9 . Check for any leaks from around the filter,

hosing or pipeworks .

10 . Replace the front cover .