ABACUS Pisces Информационный пакет - Страница 11

Просмотреть онлайн или скачать pdf Информационный пакет для Ванны ABACUS Pisces. ABACUS Pisces 17 страниц. Adjustable height bath

Bath Shell

This requires two people. Firstly connect the handset as per FIG3. Remove the 10 x 15mm M6 screws

located in the underside of the bath.

The bath needs careful guiding to locate the rods into the seal housings without damaging the seals. Ensure

that there is silicone grease in the seal area and the seals are clean and free from any dirt.

Identify the waste end of the bath to ensure the bath is the correct the way round.

Gently and evenly guide the bath shell down over the platform rods whilst ensuring the bath is kept as level

as possible. Once fully lowered into place the bath should sit firmly. Now use the handset to raise the bath

as high as it will go.

Using the 10 x 15mm M6 screws locate the pre-drilled holes in the underneath of the bath and refit the

screws to hold the bath shell in position. The floor fixing bolts should now be fully tightened.

6/ Electrical connections

Connect the actuators using the colour reference Zip ties on the actuator and wires. Ensure the retaining

clips are in place and also ensure that the cable is not allowed to dangle as this cause the wires to become

hooked up on hoist legs or mops.

Abacus Pisces 069/Info.P 04/14v1a