ABACUS VESSINI Инструкции по установке - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по установке для Внутренняя отделка ABACUS VESSINI. ABACUS VESSINI 4 страницы. Curved & square under basin furniture

Печатать страницу

Installation

Note: Vessini Under Basin Furniture has not been

designed to carry the weight of the basin above.

Please ensure that the basin is adequately fixed using

basin fixing bolts prior to installation of the under basin

furniture.

Using a pencil & level, mark a line 80mm beneath the

underside of your basin, then mark a central vertical

line following the centre of your basin to ensure even

spacing to either side. Use either Fig. 1 or 2 according to

your choice of unit to find and mark the location for the

wall fixing brackets. Mark a hole centrally at each three

fixing points on either bracket (this will allow for any

adjustment) then drill 8mm dia holes using a suitable

drill. Insert a plug into each hole then fix the wall

brackets in place using 6 No. 40mm screws supplied.

The edges of the brackets should just touch the inside

edges of the basin furniture; if this is not the case, loosen

the screw fixings slightly and re-adjust before then re-

tightening the screw fixings. Do not overtighten.

Mark out the location of the two adjustable furniture

brackets with a pencil to the dimensions noted in Fig.

3, then fix to the inside of the basin furniture using 4 No.

screw fixings supplied. Do not overtighten.

TIP: The two brackets are marked 'L' and 'R' to signify

which side they should be located against.

NOTE: The brackets have bolt fixings on the base and

rear to allow fine adjustment. These will allow you

release / pull the unit to the wall and also to raise or

lower the unit to the basin above (see Fig. 4).

Fig. 1 - Square Under Basin

Wall Bracket Set Out Detail

Fig. 2 - Curved Under Basin

Wall Bracket Set Out Detail

Fig. 3 - Set Out Detail for Furniture Brackets

Fig. 4 - Fine Adjustment Achievable