Aqua PRO APC3000 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Насос для плавательного бассейна Aqua PRO APC3000. Aqua PRO APC3000 11 страниц. Automatic pool cover pump
Печатать страницу
Safety Information (continued)
CAUTION: Know the pump and its applications, limitations,
and potential hazards.
CAUTION: Secure the pump to a solid base. This will aid in
keeping the pump in a vertical orientation. This is critical in
keeping the pump operating at maximum efficiency. It will
also help prevent the pump from clogging resulting in
premature failure.
CAUTION: Periodically inspect the pump and system
components to ensure the pump suction screen is free of
mud, sand, and debris. Disconnect the pump from the power
supply before inspecting.
..
CAUTION: Follow all local electrical and safety codes, along
with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA)
guidelines must be followed.
IMPORTANT: The motor of this pump has a thermal
protector that will trip if the motor becomes too hot. The
protector will reset itself once the motor cools down and an
acceptable temperature has been reached. The pump may
start unexpectedly if it is plugged in.
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: Before using the pump, check the hose for
holes or excess wear, which could cause leaks, and ensure
the hose is not kinked or making sharp angles. A straight
hose allows the pump to move the greatest amount of water
quickly, and also check that all hose connections are tight to
minimize leaks.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-free
service for a long time when properly installed, maintained,
and used. However, inadequate electrical power to the pump,
dirt, or debris may cause the pump to fail. Please carefully
read the manual and follow the instructions regarding
common pump problems and remedies.
IMPORTANT:
the water level is over 2 in., the water detector senses water.
Then the control system built in the pump automatically starts
the pump and the pump continues to run until water is
pumped down to 3/8 in. deep, and then it stops. If the water
level is not over 2 in., the pump will not start.
3
This pump is fully automatic in operation. If