DFI EC910-8MM Руководство пользователя - Страница 14
Просмотреть онлайн или скачать pdf Руководство пользователя для Компьютерное оборудование DFI EC910-8MM. DFI EC910-8MM 15 страниц. Nxp i.mx8m mini processor ruggedized fanless embedded system
Также для DFI EC910-8MM: Руководство по быстрой установке (16 страниц)
Печатать страницуChapter 3 - Hardware Installation
X Removing the Chassis Cover
Please observe the following guidelines and follow the instructions to open the system.
1. Make sure the system and all other peripheral devices connected to it have been
powered off.
2. Disconnect all power cords and cables.
Step 1:
The 2 screws on the both sides of the system are used to secure the cover to the chassis.
Remove the screws and put them in a safe place for later use.
Step 2:
Slide the cover to open the system.
User's Manual | EC900-8MM / EC910-8MM
X Installing an M.2 Card
Please follow the steps below to install the card into the socket.
M.2 Module
Stand-off
M.2 Module
Notch
Stand-off
Notch
Step 1:
Insert the card into the socket at an angle while making sure the notch and key are
perfectly aligned.
M.2 Module
M.2 Socket
Stand-off
Notch
Key
Step 2:
Press the end of the card far from the socket down until against the stand-off.
Step 3:
Screw tight the card onto the stand-off with a screw driver and a stand-off screw until
the gap between the card and the stand-off closes up. The card should be lying parallel
to the board when it's correctly mounted.
Chapter 3
HARDWARE INSTALLATION
M.2 Module
M.2 Socket
Stand-off
Notch
M.2 Sockets
M.2 Socket
Key
Key
M.2 Socket
Key
14