Abacus Electric Evolve Sonix Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Система безопасности Abacus Electric Evolve Sonix. Abacus Electric Evolve Sonix 10 страниц. Wireless gsm alarm

Печатать страницу

Note:

a. The symbol ' * ' in the table mentioned above means the standard setting.

b. One beep at the telephone operations mentioned above means that the input was right; the long beep

means that the sentence was input successfully and two short beeps mean that the input has failed

and it is necessary to try it again.

c. At the SMS operation mentioned above you receive the confirming message in one of the following

forms after sending the control command: DisArm, Sms: ON, Phone: ON, Siren: ON, Center Tel: OFF,

Arm Center Tel: OFF, DisArm Center Tel: OFF. According to it you´ll find out the actual status of

the base drive (activated, deactivated, alarm); if the sent SMS is the real description

d. By sending the command it is possible to check out the actual state of the device.

e. When the failure of the external power supply occurs the alarm sends for information the SMS

message "Power changer off". After the resumption of the external power supply the alarm will send

for information the SMS message "Power changer on".

How to use the remote control?

Alarm activation

Partial activation

The remote control has four buttons:

- The full activation: this activates the alarm for the situation when nobody is at home. All the sensors

are active and the green warning light will slowly blink on the alarm main drive

- The deactivation: this deactivates all the sensors and also the main drive, on which the green warning

light will shine continuously

- The partial activation: this activates the alarm for the situation when somebody is at home and so the

inner sensors are deactivated and only the outside sensors stay active. The people inside can

comfortably move without activating the alarm, but whoever would try to break into the house from the

outside he/she will activate the alarm

- The alarm (SOS button): this activates the immediate emergency alarm, e. g. in case of hold-up, in

situation when the alarm is turned off in the deactivated mode. The red warning light will blink on the

alarm main drive and the system will trigger the alarm, send the SMS and dial the preset numbers

How to add more sensors?

You can add other sensors as e. g. wireless door sensors, PIR sensors, gas and smoke detectors and so on,

to the alarm main drive.

A) The added sensors cooperate with the modes both Full activation and Partial activation:

When you activate the GSM module the LED warning light on the device will go red for 20 seconds. That

indicates that the process of code clearing is going on. In this time you can switch on other sensors and

the red warning light blinking will confirm you that they were successfully paired to the main drive. The

coding mode will end automatically after 20 seconds and the alarm will switch over to the working mode

where the LED warning light on it will change at first to yellow and then to green.

Alarm deactivation

SOS button