Aqua Select 832402B Краткое руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Лестницы Aqua Select 832402B. Aqua Select 832402B 12 страниц. Everest above-ground pool step
Печатать страницу
The two long handrail posts (A) should be installed into the holes located at the
•
back of the step.
•
When installing these posts, make sure that the closed end goes into the opening
and that the open end is facing up.
Once in place, secure using (2) screws from hardware bag (J).
•
NOTE
•
Attach mounting brackets by screwing into deck through two of the three holes on each mounting
bracket (choose the openings that best fits your deck). The screws necessary for attachment are
NOT included as there are several types of deck materials and the necessary screws will vary.
NOTE
8
If you are having a problem getting the handrail posts in due to the
sand, rock the step left and right to distribute sand.
**IF YOU ARE INSTALLING THE AQUA SELECT® EVEREST STEP with FLIP UP
OUTSIDE LADDER PLEASE REFER TO 832420 INSTRUCTIONS AT THIS TIME.
**IF YOU ARE INSTALLING THE AQUA SELECT® EVEREST BRIDGE SYSTEM, PLEASE
REFER TO 832405B INSTRUCTIONS AT THIS TIME.
Step MUST be secured to deck to prevent rocking or tipping. If the mounting
brackets do not reach the deck, you will need to extend that part of the deck
surface so that the brackets can be screwed in place.
STEP 8
STEP 9
•
If you are reading this step, then you will be attaching
this staircase to an existing deck at the pool site. If you
are NOT installing this step to a deck, please refer to
the above notes for your next step.
•
Locate mounting brackets (F) and slide one over each
of the long handrail posts. These will be used to secure
your step to your decking.
•
Adjust mounting brackets height-wise so that they are
even with your deck. Once these are even, make sure
step is where you would like it in pool. Make sure the
upright posts are as close as possible to pool top rails.