AVS RS4R-2020 Руководство по установке

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильная электроника AVS RS4R-2020. AVS RS4R-2020 8 страниц. Parking sensors

AVS PARKING SENSORS – INSTALL GUIDE

INTRODUCTION

Thank you for purchasing an AVS parking sensor system.

This system is designed to be installed by a professional installer with the appropriate qualifications, experience and tools and

is not suitable for DIY installation.

The AVS parking sensor system is suitable for vehicles with a 12VDC power system.

Sensors can be painted prior to installation; we recommend using PLASTIC ADHESION PROMOTER before ACRYLIC colour and

clear coats. Do not allow paint to run into the ring/gap on the sensor head as this may significantly effect sensitivity.

SENSOR PLACEMENT

Sensors must be installed on the outermost points on the front and/or rear of the vehicle. Vehicle parts which extend

further than the sensor position (e.g. bull bars & towbars) may cause false triggers. Position sensors accordingly.

The sensors must be installed at a height of between 40cm and 60cm from the ground.

The surface chosen must be vertical and flat (avoid uneven areas).

STEP 1 – FITTING THE SENSORS

Measure the width of the vehicle and divide by 8.

Measure 1/8

from each side and mark location using a marker.

Measure from both marks in 2/8

Use included hole saw to drill holes at each mark.

Fit the sensors and run the sensor cables to the control module.

See the next page for diagrams.

MODELS COVERED BY THIS GUIDE: RS4R-2020, RS8

and mark. You now have four marks.

Last updated: July 2020