ABATEMENT PREDATOR PRED750 Руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Скребок ABATEMENT PREDATOR PRED750. ABATEMENT PREDATOR PRED750 20 страниц. Portable air scrubber
Печатать страницу
- 1. Key Components
- 2. General Information
- 3. Electrical Requirements
- 4. Requirements for Safe Operation
- 5. Important Safety Instructions
- 6. Operating the Unit
- 7. Daisy Chaining
- 8. Filter Change Indicator
- 9. User Servicing Instructions
- 10. Filter Replacement
- 11. Filter Change Procedure
- 12. Specification
- 13. Troubleshooting Guide
- 14. Component Replacement
- 15. Certification of Room Air Filtration Units
- 16. Limited Warranty
CORD WRAP
The PRED750 has a built-in cord wrap for storing the power cord when not in use. It is important that the cord
is wrapped to help protect the cord from damage during transport and storage. Wrap the cord as shown in the
picture below and secure the plug head to the cord using the integrated clip.
USER SERVICING INSTRUCTIONS
Abatement Technologies' portable air scrubbers are designed to be low maintenance devices and basic
maintenance should be performed as follows:
•
Filters should be changed as needed based on the filter change indicator light. Follow the FILTER
CHANGE PROCEDURE as described in this manual. Filters can be changed earlier, if desired, to maintain
a minimum required flow rate.
•
The unit should be cleaned with a damp cloth or a water-based cleaner/sanitizer as needed. Do not use
harsh chemicals, solvents or detergents to clean the unit. Warning: Keep electrical components dry as
their exposure to liquids poses a safety hazard and can damage components.
•
Test the GFCI located on the unit's control panel on a monthly basis to ensure proper operation.
1. Plug the unit in and verify that the GFCI on the control panel is receiving power by ensuring the
green light in the corner of the GFCI is illuminated.
2. Depress the "TEST" button until you hear a click; the green light on the GFCI should turn off.
3. Depress the "RESET" button on the GFCI until you hear a click; the green light on the GFCI
should turn on.
9