Avtech AVM332 Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Камера безопасности Avtech AVM332. Avtech AVM332 16 страниц.

Печатать страницу

 Installation

(Continued)

Type 2

Step5: Slightly adjust the camera lens to where it's supposed to

face, and replace Part 1 and Part 2 back, as shown in

Figure 5 and Figure 6.

Step6: Hold the camera lens and Part 1, and rotate only Part 2

clockwise, as shown in Figure 6.

Figure 5

Part 1

Figure 6

Part 2

Hold camera & Part 1, and

rotate only Part 2 clockwise

Step7: Power on your camera, and check the viewing angle on

the PC.

Step8: Adjust the position and the viewing angle of the camera, if

necessary.

 Camera Configuration

For advanced configuration of your camera, please be sure you have

connected your camera to NVR as shown in "HD System

Connection".

Note: It's recommended to connect the camera to the same brand's NVR to get

the best performance. To use the camera individually, please refer to the

camera's operation guide supplied in the CD to know how to configure this

camera solely.

 Focus Adjustment

(For Type 1 only)

If you need to adjust the focus, the picture below shows you how:

Lens

for adjusting focus

for adjusting focal length

Note: Remove the cover to focus the camera.

Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.

Step2: Search available devices with "IPScan.exe"; to download "IPScan.exe", please browse the supplied CD, or visit

www.surveillance-download.com/user/IPscan.zip

Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as "192.168.30.xxx" (xxx could be 0~255)

in our example

Step4: Note down the IP address and port number of the camera you want to access, such as "192.168.30.1" and "88" in our example.

Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the camera. The format is

http://ipaddress:portnum, such as http://192.168.30.1:88 in our example.

 Insert MicroSD Card

(For Type 1 only)

The data originally saved in the micro SD card (if any) will be removed

after inserting it to the camera.

The camera doesn't support hot-swapping. Please insert or remove the

micro SD card with power disconnected.

Please follow the directions in the below graphic to insert Micro SD card

properly:

Note: It's recommended to use a pair of tweezers for inserting / removing

Micro SD card.