Allied Telesis Rapier Series Примечание к выпуску - Страница 3
Просмотреть онлайн или скачать pdf Примечание к выпуску для Сетевой маршрутизатор Allied Telesis Rapier Series. Allied Telesis Rapier Series 8 страниц. How to set up pppoe between a linux client and access concentrator
Также для Allied Telesis Rapier Series: Руководство по устранению неполадок (8 страниц), Устранение неполадок (5 страниц), Как настроить (9 страниц), Как сделать (8 страниц)
Печатать страницу
Patch 86253-03 For Rapier Series Switches
Patch 86253-03 for Software Release 2.5.3
C613-10382-00 REV B
PCR: 03609
Module: OSPF
The IP route filter did not always work correctly for OSPF. This issue has
been resolved.
PCR: 03657
Module: SWI
Executing the DISABLE SWITCH PORT command on a port that was the
source of a mirror port did not disable the mirror port. This issue has been
resolved.
PCR: 03691
Module: DVMRP
A fatal error occurred if the number of DVMRP interfaces being added
exceeded the limit. This issue has been resolved.
PCR: 03692
Module: BGP
Occasionally a fatal exception may have occurred when sending BGP
aggregate routes. This issue has been resolved.
PCR: 03696
Module: IPG
IGMP snooping entries were not being deleted from the hardware table.
This issue has been resolved. Also, port timers are now updated when the
IGMP timeout is changed.
PCR: 03698
Module: DVMRP
The output of the SHOW DVMRP FORWARDING command did not
display the forwarding ports. This issue has been resolved.
PCR: 03707
Module: STP
When adding a port to a VLAN, any STP ports that had been disabled in the
default STP were re-enabled. This issue has been resolved.
PCR: 03708
Module: DHCP
When the DELETE DHCP RANGE command was executed, DHCP
attempted to reclaim the addresses in that range. It also tried to reclaim
addresses in that range that were not allocated at that time, resulting in
duplicate addresses appearing on the free list for allocation. This has been
resolved by allowing DHCP to reclaim only those addresses that are
currently in use by one of its clients.
PCR: 03720
Module: STP
When changing from RSTP to STP mode, the STPCOMPATIBLE option for
the RSTPTYPE parameter incorrectly appeared in the dynamic
configuration. Also, when changing from RSTP to STP mode or vice versa,
disabled STP ports did not remain in the disabled state. These issues have
been resolved.
PCR: 03738
Module: IPG
If a port went down, the port was deleted from the appropriate static IGMP
associations but was not added back again when it came back up. Similarly,
static IGMP associations were automatically deleted but not added back
when IP or IGMP was disabled. These issues have been resolved. You can
now create IGMP associations before enabling IGMP, and they will become
active when IGMP is enabled.
3
Level: 1
Level: 3
Level: 2
Level: 2
Level: 2
Level: 3
Level: 2
Level: 2
Level: 2
Level: 2