DGT Bluetooth e-Board Руководство по установке - Страница 12
Просмотреть онлайн или скачать pdf Руководство по установке для Настольная игра DGT Bluetooth e-Board. DGT Bluetooth e-Board 15 страниц.
Также для DGT Bluetooth e-Board: Руководство (9 страниц), Руководство (8 страниц)
Печатать страницу
The RabbitConnect program connects the e-Board to the PC and is used for checking and troubleshooting purposes
or can be used when setting changes within the RabbitPlugin driver are required. Changes made in this program will
be saved after program closing and will apply for all programs that use the connected e-Board and the RabbitPlugin
driver.
After launching RabbitConnect, the main window will show the DGT e-Board. It is likely that there are no chess figures
shown on the board picture. To test the e-Board it is a good moment to place all chess pieces on the DGT e-Board.
If you do not see a chessboard displayed then the wrong COM port is selected.
Click on the "Settings" menu
Choose "Configure driver"
Choose the "Connection" Tab first.
Select I the pull-down menu the port that is used for your e-Board.
See the next picture for details.
After a few seconds (up to 10) the big square box should turn green and show "Board alive". Depending if you have a
DGT3000 or DGT XL clock connected, the second box will also turn green and a clock version will be visible.
Important: In some cases, the correct port number was not selected correctly in the RabbitPlugin Select port table
and the ''Board alive'' box does not turn green. In that case check the used Bluetooth (or USB) COM Port number in
your Windows control panel (see below picture where the COM Port is "COM7"), change the port number in
RabbitConnect and close and restart the RabbitConnect program again.
MA_ENG_Bluetooth Installation Manual_Rev 1508
12