Dell Vostro A180 Руководство по эксплуатации - Страница 15

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Ноутбук Dell Vostro A180. Dell Vostro A180 31 страница.

Back to Contents Page

Replacing Memory Module(s)

Dell™ Vostro™ A100/A180 Service Manual

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

1. Follow the procedures in

Before You

2. Remove the computer cover (see

3. Locate the memory modules on the system board (see

4. Press out the securing clip at each end of the memory module connector.

securing clip

memory module connector

5. Grasp the module and pull it upwards.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

NOTICE:

Do not install ECC memory modules.

NOTICE:

For Dell™ Vostro™ A180 — If you remove your original memory module(s) from the computer during a memory upgrade, keep them

separate from any new module(s) that you may have, even if you purchased the new module(s) from Dell™. If possible, do not pair an original

memory module with a new memory module. Otherwise, your computer may not start properly.

NOTE:

For Vostro A180 — If you install mixed pairs of PC2-5300 (DDR2 667-MHz) and PC2-6400 (DDR2 800-MHz) memory, the modules function at the

speed of the slowest module installed.

6. Follow the instructions below to install memory modules, depending on your computer model:

For Vostro A100 — Ensure that you install a single memory module in DIMM connector 1.

For Vostro A180 — Ensure that you install a single memory module in DIMM connector 1, the connector closest to the processor, before you install a

module in the other connector.

7. Align the notch on the bottom of the module with the tab in the connector slot.

Begin.

Replacing the Computer

Cover).

System Board

Components).