Dell Inspiron 620 Руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Настольный компьютер Dell Inspiron 620. Dell Inspiron 620 44 страницы. Quick reference guide
Также для Dell Inspiron 620: Руководство по обновлению (17 страниц), Быстрый старт (2 страниц), Краткое справочное руководство (48 страниц)
Печатать страницу
1 PCI Express x16 card slot 2 PCI Express x16 card
4. Replace the card retention bracket (see
5. Connect any cables that should be attached to the card.
See the documentation that shipped with the card for information about the card's cable connections.
CAUTION:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly
or cause damage to the equipment.
6. Replace the computer cover (see
7. Reconnect the computer and devices to electrical outlets, and then turn them on.
8. To complete the installation, see
Configuring Your Computer After Removing or Installing the PCI Express Card
NOTE:
For information about the location of external connectors, see the Setup Guide. For information on installing drivers and software for your card,
see the documentation that shipped with the card.
Installed
Sound
1. Enter system setup (see
card
System
Setup).
2. Go to Onboard Audio
Controller and then
change the setting to
Disabled.
3. Connect the external
audio devices to the
sound card's connectors.
Network
1. Enter system setup (see
card
System
Setup).
2. Go to Onboard LAN
Controller and then
change the setting to
Disabled.
3. Connect the network
cable to the network
card's connector.
Back to Contents Page
Replacing the Card Retention
Replacing the Computer
Cover).
Configuring Your Computer After Removing or Installing the PCI Express
Removed
1. Enter system setup (see
System
Setup).
2. Go to Onboard Audio
Controller and then
change the setting to
Enabled.
3. Connect the external
audio devices to the
computer's back panel
connectors.
1. Enter system setup (see
System
Setup).
2. Go to Onboard LAN
Controller and then
change the setting to
Enabled.
3. Connect the network
cable to the integrated
network connector.
Bracket).
Card.