Dell Force10 S50N Series Краткое руководство по эксплуатации - Страница 19
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сервер Dell Force10 S50N Series. Dell Force10 S50N Series 25 страниц. Rapid equallogic configuration series configuration introduction array: ps4100 host: vmware esxi
Также для Dell Force10 S50N Series: Руководство по внедрению (9 страниц)
Печатать страницуConfigure the Enable Password
The EXEC Privilege mode is accessed by the enable command. Configure a
password as a basic security measure. When using a console connection, EXEC
Privilege mode is unrestricted by default; it cannot be reached by a VTY
connection if no password is configured. There are two types of enable
passwords:
•
enable password stores the password in the running/startup configuration
using a DES encryption method.
•
enable secret is stored in the running/startup configuration in using a
stronger, MD5 encryption method.
Dell Force10 recommends using the enable secret password.
Task
Create a password to
access EXEC
Privilege mode.
Create a VLAN
The Default VLAN is part of the system startup configuration, and is by default,
VLAN 1. You may make another VLAN the Default VLAN. The Default
VLAN cannot be deleted, disabled, or configured (you cannot assign it an IP
address), and only untagged interfaces can belong to it.
When an interface is configured, a switchport automatically places it in the
default VLAN as an untagged interface. All switchports must belong to at least
one VLAN, so to remove a switchport from the Default VLAN, you must place
it as tagged or untagged in some other VLAN, or remove the switchport
configuration.
Task
Create a VLAN
Display all VLANs.
Command Syntax
enable [password | secret] [level level]
[encryption-type] password
Command Syntax
interface vlan vlan-id
show vlan vlan-id
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
EXEC Privilege
Installing the Software
17