Dell PowerEdge 300 Руководство по проверке - Страница 18
Просмотреть онлайн или скачать pdf Руководство по проверке для Сервер Dell PowerEdge 300. Dell PowerEdge 300 27 страниц. Power supply update
Также для Dell PowerEdge 300: Обновление (2 страниц)
Печатать страницу7-18 Installation and Troubleshooting Guide
Troubleshooting System Memory
A system memory problem can be a faulty dual in-line memory module (DIMM) or a
faulty system board. If a random-access memory (RAM) error message appears, the
system probably has a memory problem.
When you turn on or reboot the system, the <Caps Lock> and <Scroll Lock> indica-
tors on the keyboard should flash momentarily and then turn off. If Num Lock in
the System Setup program is set to On, the <Num Lock> indicator should flash
momentarily and then remain on; otherwise, it should turn off. Abnormal operation of
these indicators can result from a defective DIMM in socket DIMM_A.
Follow these steps to troubleshoot system memory:
1.
Turn on the system, including any attached peripherals.
Is there an error message indicating invalid system configuration information
after the memory count is completed?
Yes. Go to step 2.
No. Go to step 10.
2.
Enter the System Setup program and check the System Memory setting.
See "Using the System Setup Program" in the User's Guide for instructions.
Does the amount of memory installed match the System Memory setting?
Yes. Go to step 10.
No. Go to step 3.
3.
Turn off the system, including any attached peripherals, and disconnect the
power cable from the electrical outlet.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety
instructions at the front of this guide.
4.
Remove the computer cover.
See "Removing the Computer Cover," earlier in this chapter.
5.
Remove the support panel.
Turn the two thumbscrews on the support panel and pull the tabs on the right
side of the panel out of the slots in the chassis.
6.
Reseat the DIMMs in their sockets.
See "Adding Memory" for instructions on removing and replacing DIMMs.