Dell POWEREDGE 4300 Руководство по установке - Страница 22

Просмотреть онлайн или скачать pdf Руководство по установке для Сервер Dell POWEREDGE 4300. Dell POWEREDGE 4300 28 страниц. System board upgrade
Также для Dell POWEREDGE 4300: Информация об установке (6 страниц), Установка стойки (37 страниц), Руководство по установке обновления (14 страниц), Установка стойки (34 страниц), Руководство по обновлению (23 страниц), Руководство по обновлению (24 страниц), Руководство по установке (12 страниц), Руководство по замене (3 страниц), Информация об установке (6 страниц), Руководство по установке (14 страниц)

1-16

Dell PowerEdge 4x00 and 6300 Systems Tower Installation Guide

Reinstall the front-panel inserts to match the new drive orientation.

Slide the system board tray out to the service position.

See " Accessing the Interior of Your Computer" in your system's Installation and

Troubleshooting Guide for instructions.

Remove the drives from the drive bays:

Disconnect the DC power cable and the interface cable from the back of the

drive. Be sure to record the power connector number and the location of the

interface connector.

Press inward (toward the center of drive) on the two drive release tabs, and

slide the drive out of the bay.

If any of the drive bays are empty, remove the metal insert(s) covering the

bay(s) and reinsert them in the proper orientation.

Reinstall the external drives to match the new system orientation:

Slide each drive into the bay until it snaps securely into place.

Reconnect the appropriate DC power cable and interface cable to each drive.

7 .

Close the system board tray.

Reorienting the System Badge

To rotate the system badge on the front bezel, perform these steps:

Facing the inner side of the bezel, remove the system badge by compressing the

tabs extending through the slots in the bezel, and push the badge out of its

frame.

Rotate the badge 90 degrees to match the new orientation of the system.

Facing the outer side of the bezel, install the new system badge by inserting the

tabs through the slots in the face of the bezel until the tabs snap into place.

To replace the front bezel of the system, perform these steps:

Align the three clips on the edge of the bezel and press the bezel into place until

the tabs on the opposite edge of the bezel snap into place.

Reinstall the system cover.