Dell E2009W Руководство пользователя - Страница 26

Просмотреть онлайн или скачать pdf Руководство пользователя для Монитор Dell E2009W. Dell E2009W 30 страниц. Lcd monitor
Также для Dell E2009W: Руководство по настройке (2 страниц), Руководство по эксплуатации (49 страниц)

Печатать страницу

Back to Contents Page

Troubleshooting

Dell™ E2009W/E2209W Flat Panel Monitor User's Guide

Troubleshooting Your Monitor

Common Problems

Product Specific Problems

CAUTION:

Before you begin any of the procedures in this section, follow the

Troubleshooting Your Monitor

Self-Test Feature Check

Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly

connected but the monitor screen remains dark, run the monitor self-test by performing the following steps:

1. Turn off both your computer and the monitor.

2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove both Digital (white connector) and the Analog (blue

connector) cables from the back of computer.

3. Turn on the monitor.

The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.

While in self-test mode, the power LED remains blue. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll

through the screen.

4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged.

5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning

properly.

Built-in Diagnostics

Your monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, or

with your computer and video card.

NOTE:

You can run the built-in diagnostics only when the video cable is unplugged and the monitor is in self-test mode.

To run the built-in diagnostics:

1. Ensure that the screen is clean (no dust particles on the surface of the screen).

2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self-test mode.

3. Press and hold the

and

4. Carefully inspect the screen for abnormalities.

5. Press the

button on the front panel again. The color of the screen changes to red.

6. Inspect the display for any abnormalities.

7. Repeat steps 5 and 6 to inspect the display in green, blue, and white colored screens.

The test is complete when the white screen appears. To exit, press the

If you do not detect any screen abnormalities upon using the built-in diagnostic tool, the monitor is functioning properly. Check the video card and computer.

Common Problems

The following table contains general information about common monitor problems you might encounter and the possible solutions.

Common Symptoms

Experience

No Video/ Power LED off

No picture

buttons on the front panel, simultaneously for 2 seconds. A gray screen appears.

What You

Ensure that the video cable connecting the monitor and the computer is properly connected and secure.

Safety Instructions

button again.

Possible Solutions