Allied Telesis SB251-08 Примечание к выпуску - Страница 7

Просмотреть онлайн или скачать pdf Примечание к выпуску для Программное обеспечение Allied Telesis SB251-08. Allied Telesis SB251-08 12 страниц. Patch for switchblade 4000 series switches and at-9800 series switches

Печатать страницу

Patch SB251-08 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches

Patch SB251-08 for Software Release 2.5.1

C613-10361-00 REV H

PCR: 03060

Module: CORE, SWI

Support has been added, to the MIB-2 interface MIB, for the port interface.

This means that port counters can now be shown.

PCR: 03066

Module: SWI

If a hardware filter was added to the switch, with a source VLAN and a

destination port of 1, then a host connected to the switch could not PING a

host on a different port. This issue has been resolved.

PCR: 03071

Module: CORE

An unexpected restart that occurred when upgrading a SwitchBlade from

Release 2.4.4 to Release 2.5.1 was caused by NVS generating an SNMP trap.

This issue has been resolved.

PCR: 03079

Module: IPG, SWI

Static routes were occasionally not added to all hardware tables across all

instances. This would affect connectivity if an instance had a default route

added to its table that pointed out one of its ports. This issue has been

resolved.

PCR: 03088

Module: SWI

Ports could not be added to the default VLAN after a hotswap, if the default

VLAN was Protocol, Subnet, MAC address, or Limited protocol based. This

issue has been resolved.

PCR: 03105

Module: FIREWALL

Incorrect handling of TCP sessions, and poor load balancing performance

could be caused by TCP virtual balancers not selecting a new resource if

required. This issue has been resolved.

PCR: 03112

Module: IPV6

The ADD IPV6 ND command now has a PORT parameter which means that

it can be associated with the VLAN parameter.

PCR: 03118

Module: CORE

Changes have been made to the SysDescription.

PCR: 03119

Module: CLASSIFIER

TCP source and TCP destination ports were swapped when viewed in the

GUI. This issue has been resolved.

PCR: 03138

Module: SWI

Packets that were sent out a default route could have an incorrect source IP

address, if the interface route to the destination IP address existed but was

down. This issue has been resolved.

PCR: 03141

Module: IPG

Packets could be sent with an incorrect source address if a route was added

to a VLAN and another VLAN had an IP interface configured that was in

the same subnet as the route. This issue has been resolved.

Level: 3

Level: 2

Level: 1

Level: 2

Level: 3

Level: 4

L evel: 2

Level: 3