Dell E11J Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Хранение Dell E11J. Dell E11J 45 страниц. Storage center
Также для Dell E11J: Руководство по началу работы (7 страниц), Руководство пользователя (39 страниц)

Печатать страницу
Dell E11J Руководство пользователя
Item Control/Feature
4
REPL port
5
SAS activity indicators
6
Storage controller
module status
7
Recessed power off
button
8
Storage controller
module fault
9
Recessed reset button
10
Identification LED
11
USB port
12
Diagnostic LEDs (8)
13
Serial port (3.5 mm mini
jack)
14
Four or two Fibre
Channel ports with three
LEDs per port
15
Mini-SAS port B
12
Icon Description
NOTE: To use the MGMT port as an iSCSI port for
replication to another Storage Center, a Flex Port license
and replication license are required. To use the MGMT port
as a front-end connection to host servers, a Flex Port
license is required.
—
10 Mbps, 100 Mbps, or 1 Gbps Ethernet/iSCSI port used for
replication to another Storage Center (requires a replication
license)
NOTE: To use the RELP port as a front-end connection to
host servers, a Flex Port license is required.
—
•
Off: Port is off
•
Steady green: Port is on, but without activity
•
Blinking green: Port is on and there is activity
On: Storage controller completed POST
Powers down the storage controller if held for more than five
seconds
•
Off: No faults
•
Steady amber: Firmware has detected an error
•
Blinking amber:Storage controller is performing POST
Reboots the storage controller forcing it to restart at the POST
process
•
Off: Identification disabled
•
Blinking blue (for 15 sec.): Identification is enabled
•
Blinking blue (continuously): Storage controller shut down
to the Advanced Configuration and Power Interface (ACPI)
S5 state
—
•
Green LEDs 0–3: Low byte hex POST code
•
Green LEDs 4–7: High byte hex POST code
Not for customer use.
—
•
All off: No power
•
All on: Booting up
•
Blinking amber: 2 Gbps activity
•
Blinking green: 4 Gbps activity
•
Blinking yellow: 8 Gbps activity
•
Blinking amber and yellow: Beacon
•
All blinking (simultaneous): Firmware initialized
•
All blinking (alternating): Firmware fault
Back-end expansion port B
Get other manuals https://www.bkmanuals.com
About the SCv2080 Storage System