3 Day Blinds 2 Начало работы - Страница 7

Просмотреть онлайн или скачать pdf Начало работы для Оконные жалюзи 3 Day Blinds 2. 3 Day Blinds 2 8 страниц.

BLIND REMOVAL

OPTIONAL HARDWARE

INSTALLATION

HOLD DOWN BRACKETS

Hold down brackets are used primarily on blinds mounted to

doors or in motor homes. If hold down brackets were ordered

at the time of purchase, the bottom rail of the blind will be

pre-drilled to accommodate the brackets. If you require hold

down brackets and no hole appears, simply drill a small hole

in the center of the bottom rail using a

• With the blind lowered to it's full length, place the pin of

each hold down bracket into the hole in each end of the

bottom rail.

• Mark the mounting surface, either to the side or back of the

window frame, through the holes in the hold down bracket.

Make sure the hold down brackets are level and aligned with

each other.

• Raise the blind and screw the hold down brackets into the

mounting surface using the screws provided.

• Mount the hold down bracket to the side or back of the

window frame so that the pin lines up with the front hole in

the bottom rail end cap with the blind fully lowered.

| 2 & 2

" Wood & Faux Wood & Angled Slat Blinds

• Using a flathead

screwdriver, open the

latches of the end

brackets.

• Holding onto both ends

of the headrail, gently

pull the blind forward

and out of the brackets,

making sure to unhook

the headrail from the

center support bracket(s),

if applicable.

" drill bit.

• Lower the blind and

flex the hold down

bracket outward so

that the pin can be

inserted into the hole

in the bottom rail.