Dell PowerVault MD3200 Series Белая книга - Страница 9

Просмотреть онлайн или скачать pdf Белая книга для Хранение Dell PowerVault MD3200 Series. Dell PowerVault MD3200 Series 22 страницы. Storage arrays
Также для Dell PowerVault MD3200 Series: Руководство по обновлению (32 страниц), Инструкции по установке стоек (2 страниц), Матрица поддержки (12 страниц), Руководство по установке (18 страниц), Руководство по развертыванию (38 страниц), Обновление информации (1 страниц), Матрица поддержки (17 страниц), Техническое руководство (40 страниц), Руководство по развертыванию (38 страниц), Руководство по развертыванию (38 страниц)

Planning for Hyper-V: PowerVault™ MD3200 and MD3200i Series of Arrays

means that the storage array avoids network congestion with other non-storage traffic that is using the

network.

•

CHAP

To have secure access between your host and storage array, enable target and mutual

CHAP authentication on the hosts and storage arrays. Follow standard CHAP password

guidelines for best security. Set a strong password that meets standard IT guidelines on

all of the devices in your IP SAN.

•

Virtual LAN (VLAN)

If you want to physically isolate your IP SAN data traffic from general network traffic,

use VLANs. Turn on VLAN tagging on the Dell PowerVault MD3200i storage array. A port

can either transmit all tagged IP packets or all non-tagged IP packets.

Note: You must enable a VLAN throughout the entire iSCSI SAN from the network interface

cards (NICs) and switches to the iSCSI ports; otherwise, behavior might be inconsistent.

To simplify and avoid troubleshooting at deployment, make sure that the NICs,

switches, and storage array are fully operational before you enable the VLAN feature

for the entire solution.

IP SAN Network Infrastructure for Performance

This section describes some general implementation guidelines for performance. These guidelines

might not apply to all applications. Review your application requirements prior to implementing these

guidelines.

General Network Practices

Make sure the category rating for the cables used is gigabit-Ethernet-compliant (CAT5e or CAT6).

Design your network to have the least amount of hops between the storage arrays and the servers. This

design greatly reduces the failure points, it simplifies the manageability, and it reduces the latency

and complexity of your network architecture (particularly in the area of redundancy).

Use managed switches because they provide advance features to help you optimize and maintain your

network for your application. Only use auto-negotiation because gigabit Ethernet networks are

designed to always have auto-negotiation enabled. If a particular application requires a specific speed

or duplex mode, you can accomplish this by changing the advertisement options of the switch.

Page 7