Dell PowerVault MD3260i Series Руководство по устранению неполадок - Страница 12

Просмотреть онлайн или скачать pdf Руководство по устранению неполадок для Хранение Dell PowerVault MD3260i Series. Dell PowerVault MD3260i Series 18 страниц. Storage arrays
Также для Dell PowerVault MD3260i Series: Руководство по аппаратному и программному обеспечению (25 страниц), Руководство по установке (11 страниц), Руководство по началу работы (10 страниц), Обновление информации (8 страниц), Инструкции по установке стоек (2 страниц), Настройка (2 страниц), Руководство по устранению неполадок (20 страниц), Руководство по развертыванию (24 страниц)

Dell PowerVault MD3260i Series Руководство по устранению неполадок
No link LEDs visible on RAID
controller (rear)
Reduced throughput

Troubleshooting Management Port IP Addressing and Configuration

If problems persist, refer to the following table:
Table 5. Diagnosing Management Port Configuration Problems
Issue/Problem
What is the IP address
of the Ethernet
management port?
If you are using a network switch, verify that it is
powered on and Ethernet ports on both the network
switch and RAID controller are active. Also, make
sure the storage array enclosure is powered on.
If you have connectivity but are experiencing
reduced throughout, make sure your iSCSI port is not
connecting to the host server through a slower-than-
expected speed. For example, a 10Gb port can
connect using a 1Gb network switch, but the slower
switch will impact throughput.
Recommendation
The management port appears differently to DHCP and non-DHCP
servers:
DHCP server
(IPv4)
non-DHCP server
(IPv4)
All IPv6-enabled
configurations
On a network running DHCP server, IP
addresses for the Ethernet management ports
are assigned automatically
On a non-DHCP network server, the Ethernet
management ports will default to the following
IP addresses following a three-minute timeout
(from initial polling or connection attempt):
Controller 0:
192.168.128.101
Controller 1:
192.168.128.102
Subnet mask:
255.255.255.0
Each management port has a default link local
IP address that is based on the MAC address of
the port (unless IPv6 is specifically disabled on
a port).