Dell PowerVault NX1950 Руководство по установке и устранению неисправностей - Страница 21

Просмотреть онлайн или скачать pdf Руководство по установке и устранению неисправностей для Хранение Dell PowerVault NX1950. Dell PowerVault NX1950 48 страниц. For vmware esx server software
Также для Dell PowerVault NX1950: Руководство по развертыванию (34 страниц), Важная информация Руководство (26 страниц), Начало работы (49 страниц), Руководство по развертыванию (38 страниц), Руководство по обновлению (18 страниц), Справочное руководство (4 страниц), Настройка (2 страниц), Использование (2 страниц), Руководство по конфигурации (11 страниц)

4 After the quorum disk is created, the New Server Cluster Wizard appears.

This wizard takes you though the process of cluster creation. Click Next to

begin the process.

5 The Analyzing Configuration window appears and the system

configuration is analyzed. If a cluster configuration already exists, this step

fails. For information about correcting this error, see "Troubleshooting" on

page 35.

If no error is reported after the analysis is completed, click Next.

NOTE:

The New Server Cluster Wizard may caution you about the cluster

configuration due to the Microsoft Windows Firewall exception being enabled.

This does not impact successful cluster setup. For more information about

Firewall port exceptions, see "Firewall Port Exceptions" on page 9.

6 The IP Address window prompts you to enter the IP address. Enter the IP

address that you want to configure for the cluster and click Next.

NOTE:

This IP address is used for the cluster management (public)

connection.

7 The Cluster Service Account window appears. Enter the domain

controller administrative account information and click Next.

NOTE:

It is recommended that you create a domain account with limited

privileges for this purpose. This domain account is granted with local

administrator rights on each node and can be used for Controlling Services.

8 The Proposed Cluster Configuration window appears. This window gives

you a summary of the configuration that is being created.

Before you proceed to the next screen, click Quorum to select the

correct quorum disk. The Cluster Configuration Quorum screen

appears.

Select a quorum disk (shared quorum disk) that is accessible to both

the nodes. This is essential for a successful cluster creation.

9 After selecting the quorum disk, check for errors in the summary.

If there are errors, click Back to go to the incorrect section and correct the

error. If no errors are reported, click Next to proceed to the next screen.

10 The Creating the Cluster screen appears. This dialog box gives you the

progress of the cluster creation process and the warnings that might have

occurred during the process as shown in Figure 2-6.

Setting Up Your Cluster