Dell PowerVault TL4000 Начало работы - Страница 12

3. Lift the library out of the carton and remove the bag from the library. Remove

Verifying the Shipment

Verify that the following items are included in your library shipment:

v With every library:

v With every library containing a SCSI drive:

v With every library containing a Fibre Channel drive:

v With every library containing a SAS drive:

v Rack Mount Kit

Important: Foot pads are required for a desktop installation.

Six foot pads must be installed on the bottom of the library before the library can

be used as a desktop unit. If you intend to install your library in a rack, skip this

step and proceed to "Removing and Storing the Shipping Lock" on page 1-3.

To install the library foot pads:

1. Being very careful, lay the library on its side.

2. Peel the adhesive from the back of each foot pad.

3. Install the foot pads on the bottom of the library chassis by pressing each foot

1-2

Getting Started with the Dell PowerVault TL2000 and TL4000 Tape Libraries

the foam cushion from the back of the library. Save the packaging materials for

future use.

Important: Do not place the library on the front panel or the rear panel as this

may damage the library.

– Power cord

– Cleaning cartridge

– Bar code labels

– Foot pads (for desktop installation)

– SCSI terminator (one per SCSI drive)

– SCSI library-to-host cable

– Fibre Channel library-to-host/switch cable

–

SAS library-to-host cable (if ordered by customer)

into one of the six areas ( 1 ) as shown in the figure below.