Dell VxRail E660 Руководство по установке и обслуживанию - Страница 31
Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Хранение Dell VxRail E660. Dell VxRail E660 32 страницы.
Также для Dell VxRail E660: Руководство по установке и обслуживанию (32 страниц)
Печатать страницу
Power indicator codes
Drive indicator codes
The LEDs on the drive carrier indicate the state of each drive. Each drive carrier has two LEDs: an activity LED (green) and a
status LED (bicolor, green/amber). The activity LED blinks whenever the drive is accessed.
1. Drive activity LED indicator
2. Drive status LED indicator
3. Drive capacity label
NOTE:
If the drive is in the Advanced Host Controller Interface (AHCI) mode, the status LED indicator does not power on.
NOTE:
Drive status indicator behavior is managed by Storage Spaces Direct. Not all drive status indicators may be used.
Drive status indicator code
Blinks green twice per second
Off
Blinks green, amber, and then powers off
Blinks amber four times per second
Blinks green slowly
Solid green
Blinks green for three seconds, amber for three seconds,
and then powers off after six seconds
Condition
CAUTION:
If two PSUs are used, they must be of
the same type and have the same maximum output
power.
CAUTION:
When correcting a PSU mismatch, replace
the PSU with the blinking indicator. Swapping the
PSU to make a matched pair can result in an error
condition and an unexpected system shutdown. To
change from a high output configuration to a low
output configuration or vice versa, you must power
off the system.
CAUTION:
AC PSUs support both 240 V and 120 V
input voltages with the exception of Titanium PSUs,
which support only 240 V. When two identical PSUs
receive different input voltages, they can output
different wattages, and trigger a mismatch.
Condition
Indicates that the drive is being identified or preparing for removal.
Indicates that the drive is ready for removal.
NOTE:
The drive status indicator remains off until all drives
are initialized after the system is powered on. Drives are not
ready for removal during this time.
Indicates that there is an unexpected drive failure.
Indicates that the drive has failed.
Indicates that the drive is rebuilding.
Indicates that the drive is online.
Indicates that the rebuild has stopped.
System diagnostics and indicator codes
31