Dell Force10 MXL Blade Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Переключатель Dell Force10 MXL Blade. Dell Force10 MXL Blade 27 страниц. 10/40gbe blade switches
Также для Dell Force10 MXL Blade: Руководство по началу работы (38 страниц), Примечание по применению (6 страниц), Технические характеристики (2 страниц)

Stacking Dell Force10 MXL 10/40G Switches

Additional stack members can immediately utilize existing configuration information such as routing

and switching configurations, VLANs, ACLs, port profiles, and security certificates.

Redundancy

By connecting a cable from the last switch in a stack back to the first switch, the operator ensures that

a stack has the protection of redundant paths for control and data traffic. Support for link aggregation

groups (LAG) configured across multiple switches provides yet another layer of redundancy as well as

adding bandwidth. This means that any single point of failure (a switch or a stack cable failure) will not

affect the overall operation of the remaining stack elements. This type of stacking topology is referred

to as a "ring topology". The other stacking topology where the last and first switch are not connected

is referred to as a daisy-chain topology stack. This type of stack is much less resilient and not

recommended in most cases. Both topologies are mentioned several times in this document

If the stack Master fails (for example, loses power), it is removed from the stack topology. The Standby

unit detects the loss of peering communication and takes ownership of the stack management,

switching from Standby to Master. If a Standby was not set up by the administrator, the stack

automatically triggers an election within the remaining units to select a new Master. While a new

Master is being selected (either through election or pre-selection), a new Standy is also chosen from

the remaining members based on the same criteria as a Master selection (priority, then highest MAC

address).

After the former Master switch recovers, despite having a higher priority or MAC address, it does not

recover its Master role but instead take the next available role as Standy or Member.

When multiple links between stack members are used, the Dell Force10 MXL automatically bundles

them into a single logical link, or LAG, providing higher stacking bandwidth and redundancy. The

stacking LAG is established automatically without user configuration once all ports used in the LAG are

set in stacking mode. The LAG can lose link or gain links simply by removing or inserting the cables.

Another benefit of stacking MXL switches is that it allows a blade server to create LAGs to the stacked

switch. For example, if MXL switches are stacked in slots B1 and B2, then NICs on B1 and B2 on a given

server could be configured for LAGs/LACP

The actual stack configuration used to stack switches during power-up is read from meta-data, not

from the startup configuration. It is applied at boot time prior to starting the switch firmware and

reading the startup configuration. Stack information shown in the startup and running configurations is

simply repeating information from the meta-data for the user's knowledge. Therefore, if the startup

configuration is deleted and the switch is reloaded, it will not clear the stacking configuration and the

stack will remain intact after the reload. In order to remove the stacking configuration, the "no"

command will need to be implemented for each of the stack-unit commands that were used to create

the stack.