Dell Force10 S4810 Руководство по конфигурации - Страница 15

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell Force10 S4810. Dell Force10 S4810 17 страниц. Dell force10 s4810 switch
Также для Dell Force10 S4810: Краткое руководство по эксплуатации (27 страниц), Руководство по развертыванию (36 страниц), Руководство по конфигурации (17 страниц)

4.3

Revert to default VLAN ID on switch and arrays

Once DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that was

configured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid

VLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN can

use the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,

VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must be

configured as "untagged".

Use the steps below to configure the native VLAN on the switch.

FTOS#configure

FTOS(conf)#no interface vlan vlan-id

4.4

FTOS#copy running-config startup-config

4.5

FTOS#reload

System configuration has been modified. Save? [yes/no]yes

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

4.6

FTOS#show dcb

Figure 2

4.7

Repeat the commands from section 4 to disable DCB on any additional switches.

SCG1000

Force10 S4810 Configuration Guide

Screen shot of show DCB