Dell N4000 Series Руководство по конфигурации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell N4000 Series. Dell N4000 Series 17 страниц. Expansion modules for dell networking switches
Также для Dell N4000 Series: Справочное руководство (17 страниц)
Печатать страницу
2.10
Configure spanning tree portfast on edge ports
Note: If iSCSI optimization is enabled, spanning tree portfast is automatically configured on ports
connected to EqualLogic arrays. These manual steps must be performed on switch ports connected to
hosts servers.
console#configure
console(config)#interface range tengigabitethernet all
console(config-if)#spanning-tree portfast
console(config-if)#exit
2.11
Configure QSFP ports for LAG
These commands assign 40Gb QSFP ports to the Port Channel.
console(config)#interface range fortygigabitethernet 1/0/1-2
Note: Port numbering for the 40Gb QSFP ports may vary by switch model and module configuration.
Confirm the correct port range for your configuration.
console(config-if)#no spanning-tree portfast
console(config-if)#channel-group 1 mode active
console(config-if)#exit
2.12
Save configuration
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
2.13
Configure additional switch
Repeat the commands from Section 2 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
11
SCG1001
Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide