Dell Networking S5000 Руководство по конфигурации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell Networking S5000. Dell Networking S5000 12 страниц. Data center switch
Также для Dell Networking S5000: Руководство по установке (50 страниц), Руководство по конфигурации (17 страниц), Руководство по началу работы (37 страниц)

FTOS(conf-if-range-te-0/0-47)#switchport

FTOS(conf-if-range-te-0/0-47)#no shutdown

2.8

Enable Jumbo Frames

FTOS(conf-if-range-te-0/0-47)#mtu 12000

2.9

FTOS(conf-if-range-te-0/0-47)#flowcontrol rx on tx off

2.10

Note: Use the following command only on server- and storage-connected edge ports.

FTOS(conf-if-range-te-0/0-47)#spanning-tree rstp edge-port

FTOS(conf-if-range-te-0/0-47)#exit

FTOS(conf)#protocol spanning-tree rstp

FTOS(conf-rstp)#no disable

FTOS(conf-rstp)#exit

2.11

Note: Dell recommends assigning a unique

example, assign VLAN 100 on the first switch and VLAN 200 on the second switch. The following

example assigns all the ports to the VLAN, however, you may also assign individual ports to the VLAN

after they are enabled (Section 2.7). If you prefer to use the default VLAN, then you may skip this section

entirely.

FTOS(config)#interface vlan vlan_id

FTOS#(config-if-vl-###)#no shutdown

FTOS#(config-if-vl-###)#untagged tengigabitethernet 0/0-47

FTOS#exit

SCG2004

Dell Networking S5000 Switch Configuration Guide for SC Series SANs

vlan_id

(between 2-4094) for each switch fabric. For