Dell Networking Z9500 Руководство по началу работы - Страница 29

Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Dell Networking Z9500. Dell Networking Z9500 34 страницы. Z9500 switch
Также для Dell Networking Z9500: Руководство по установке (47 страниц)

Dell Networking Z9500 Руководство по началу работы
Figure 13. Port Numbering

Accessing the System Remotely

You can configure the system to access it remotely by Telnet.
The system has a dedicated management port and a management routing table that is separate from the
IP routing table.
1.
Configure an IP address for the management port (refer to
Address).
2.
Configure a management route with a default gateway (refer to
3.
Configure a username and password (refer to

Configuring the Management Port IP Address

To access the system remotely, assign IP addresses to the management ports.
NOTE: Assign different IP addresses to each stack-unit's management port.
1.
Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet slot/port
– slot range: 0
– port range: 0
2.
Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
– ip-address: an address in dotted-decimal format (A.B.C.D).
– mask: a subnet mask in /prefix-length format (/ xx).
3.
Enable the interface.
INTERFACE mode
no shutdown
Getting Started Guide
Configuring the Management Port IP
Configuring a Management
Configuring a Username and
Route).
Password).
29