Dell Networking Z9500 Руководство по началу работы - Страница 32
Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Dell Networking Z9500. Dell Networking Z9500 34 страницы. Z9500 switch
Также для Dell Networking Z9500: Руководство по установке (47 страниц)
Печатать страницу
Assigning an IP Address to a VLAN
VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, you must
assign an IP address to the VLANs to route traffic between the two interfaces. The shutdown command
in INTERFACE mode does not affect Layer 2 traffic on the interface.
NOTE: You cannot assign an IP address to the Default VLAN, which, by default, is VLAN 1. To assign
another VLAN ID to the Default VLAN, use the default vlan-id vlan-id command.
•
Configure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
Connecting the System to the Network
After you have completed the hardware installation and software configuration for the system, you can
connect to your company network by following your company's cabling requirements.
Figure 14. RJ-45 Network/Management Port
Technical Specifications
NOTE: Operate the product at an ambient temperature not higher than 40°C.
Table 3. Chassis Physical Design
Parameter
Height
Width
Depth
Chassis weight with factory-installed components
Rack clearance required
32
Specifications
5.2 inches (132.08 mm)
17.4 inches (441.96 mm)
32 inches (812.80 mm)
122 pounds (Approximately)
•
Front: 5 inches (12.7 cm)
Getting Started Guide