Dell PowerConnect 6248 Примечание к выпуску - Страница 23
Просмотреть онлайн или скачать pdf Примечание к выпуску для Переключатель Dell PowerConnect 6248. Dell PowerConnect 6248 34 страницы. Powerconnect 6200 series
Также для Dell PowerConnect 6248: Технические характеристики (2 страниц), Руководство по планированию и подготовке (12 страниц)
Печатать страницу
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes
CLI Reference Manual Updates
Non-Stop Forwarding
Title
nsf
no nsf
show nsf
show checkpoint statistics
clear checkpoint statistics
vlan routing vlanid [index]
nsf [ ietf ] [ planned-only ]
nsf helper [ planned-only ]
nsf [ietf] helper strict-lsa-checking
no nsf [ietf] helper strict-lsa-checking
nsf [ietf] restart-interval seconds
show ip ospf
System Firmware Version 3.2.0.6
Description
Use this command to enable non-stop forwarding. The "no" form of the
command will disable NSF.
Default: Non-stop forwarding is enabled by default.
Use this command to show the status of non-stop forwarding.
Default: Not applicable
Use this command to display the statistics for the check pointing process.
Default: Not applicable
Use this command to clear the statistics of the check pointing process.
Default: Not applicable
This command is used to enable routing on a VLAN. Us the "no" form of
the command to disable routing on a VLAN.
Default: Routing is not enabled on any VLANs by default.
Use this command to enable OSPF graceful restart. Use the "no" form of
this command to disable graceful restart.
•
ietf — This keyword is used to distinguish the IETF standard
implementation of graceful restart from other implementations. Since
the IETF implementation is the only one supported, this keyword is
optional
•
planned-only — This keyword indicates that OSPF should only
perform a graceful restart when the restart is planned (i.e., when the
restart is a result of the initiate failover command).
:
Default
Graceful restart is disabled by default.
Use this command to allow OSPF to act as a helpful neighbor for a
restarting router. Use the "no" form of this command to prevent OSPF
from acting as a helpful neighbor.
•
planned-only — This keyword indicates that OSPF should
only help a restarting router performing a planned restart.
Default: OSPF may act as a helpful neighbor for both planned an
unplanned restarts.
This command is used to require that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs. Use the "no" form of
this command to allow OSPF to continue as a helpful neighbor in spite of
topology changes.
Default: A helpful neighbor exits helper mode upon a topology change.
Use this command to configure the length of the grace period on the
restarting router. Use the "no" form of this command to revert the grace
period to its default.
•
ietf — This keyword is used to distinguish the IETF standard
implementation of graceful restart from other implementations. Since
the IETF implementation is the only one supported, this keyword is
optional.
•
seconds — The number of seconds that the restarting router asks its
neighbors to wait before exiting helper mode. The restarting router
includes the restart interval in its grace LSAs (range 1 – 1800
seconds).
Default: The default restart interval is 120 seconds.
This command has been enhanced to lists the values of the configuration
parameters described above and the status parameters defined in the
RFC 4750 MIB.
Page 21