Allied Telesis AT-AR026 4ETH Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Сетевая карта Allied Telesis AT-AR026 4ETH. Allied Telesis AT-AR026 4ETH 13 страниц. Port interface card
Также для Allied Telesis AT-AR026 4ETH: Руководство по установке (13 страниц), Руководство по быстрой установке (10 страниц), Руководство по установке и безопасности (8 страниц)

Installation and Safety Guide

AT-AR026 4ETH PICs have user-configurable links that set features such as

auto-negotiation, buffer size, and MAC address aging. For a detailed description

of the links, see the Port Interface Card Hardware Reference.

For more information on PIC jumpers and hardware configurations, see the

Port Interface Card Hardware Reference. This document can be downloaded from

www.alliedtelesis.com/support/software/.

Slide the PIC into place.

PIC bays should be filled in numerical order, starting with the lowest available

bay (e.g., bay 0) followed by bays with progressively higher numbers.

Insert the PIC slowly, being sure to keep it straight. Press firmly until you feel

the connector engage. Do not force a misaligned PIC.

10. Secure the PIC by tightening its thumbscrews.

11. Apply power to the switch or router.

Re-attach the power cord, and reconnect any redundant power supply.

12. Test the PIC.

There are several ways to check the PIC is installed and functioning correctly.

The show system command displays general system information about PICs

and any other hardware installed, as well as memory, software version and

patches loaded on the switch or router.

If the PIC does not appear in the list of boards at the top of the show system

output, then your switch or router has not recognised the PIC. Likely reasons

are:

• Your switch or router does not support the PIC. See

and Routers" on page

• Your switch or router is running a version of the AlliedWare

System that does not support the PIC. Use the show system command to

check the software version. In particular, the AT-AR021(S) V3 hardware

revision requires a switch or router running AlliedWare

version 2.9.1-13 or later.

• The PIC is not installed correctly. Repeat the installation process, paying

particular attention to step 9.

For more detailed information on testing PICs, see the Port Interface Card

Hardware Reference. You can download this document from

www.alliedtelesis.com/support/software/.

"Compatible Switches

Operating

Operating System