Dell PowerConnect M8024 Руководство по конфигурации - Страница 14
Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell PowerConnect M8024. Dell PowerConnect M8024 21 страница. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Также для Dell PowerConnect M8024: Примечание к выпуску (9 страниц), Информация о выпуске (27 страниц), Обновление микропрограммы (24 страниц)
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.14
Configure SFP+ ports for LAG (M8024)
Note: The commands in this section assign four 10Gb SFP+ ports from an optional expansion module in
the first expansion slot, to the Port Channel. If you have the M8024-k switch, see section 3.13 instead.
console(conf)#interface range tengigabitethernet 1/1/1-4
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.15
Save configuration
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
3.16
Configure additional switch
Repeat the commands from section 3 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
14
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs