Dell S4048T-ON Руководство по началу работы - Страница 24

Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Dell S4048T-ON. Dell S4048T-ON 35 страниц.

NOTE:

optics with the tabs facing up.

NOTE:

from the small vent holes above and below the ports.

Supply Power and Power Up the System

Dell Networking recommends reinspecting your system prior to powering up. Connecting the

power cable powers up the switch.

Verify that:

•

The equipment is properly secured to the rack.

•

The equipment rack is properly mounted and grounded.

•

The ambient temperature around the unit (which may be higher than the room

temperature) is within the limits specified for the system.

•

There is sufficient airflow around the unit.

•

The input circuits are correctly sized for the loads and that you use sufficient overcurrent

protection devices.

•

All protective covers are in place.

CAUTION:

ESD damage can occur if the components are mishandled. Always wear

an ESD-preventive wrist or heel ground strap when handling the system and its

components.

Supply power to the system:

•

Plug in the appropriate cord (AC 3 prong or DC wiring) from the switch PSU to the

external power source (either AC wall outlet or DC rack bus bar). Make sure that the

power cord is secure. When the cable is connected between the system and the power

source, the switch is powered up; there is no on/off switch.

•

When the system powers up, the fans come on at high speed. The fan speed slows as

the system boots up. The power status LED blinks until the boot-up sequence is

complete. When the boot up is complete, the power status LED is steadily lit.

After Installing the S4048T-ON

After you have securely installed and powered on the S4048T-ON, to configure your system,

see your ONIE-compatible operating system documentation.

Hardware installation

Both rows of QSFP+ ports require that you install the 40 GbE

When you cable the ports, be sure not to interfere with the airflow