Dell S4148-ON Руководство по конфигурации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell S4148-ON. Dell S4148-ON 19 страниц. Dell emc sc series sans

Dell EMC recommended switch configuration

2.3

Switch profiles (only for S4148-ON and its variants)

On the S4148-ON switch and its variants, switch port profiles determine the available front-panel Ethernet

ports and supported breakout interfaces on uplink ports. Refer to the switch user's guide to determine which

switch profile fits for your environment.

Note: Changing switch profiles will delete all configuration information from the switch except for the

management port configuration. Save and reload the switch for the new switch profile to take effect.

OS10# configure terminal

OS10(config)# switch-port-profile 1/1 profile-<number>

Warning: Switch port profile will be applied only after a save and reload. All

management port configurations will be retained but all other configurations

will be wiped out after the reload.

OS10(config)# exit

OS10# copy running-configuration startup-configuration

OS10# reload

Proceed to reboot the system? [confirm yes/no]yes

2.4

Note: This section applies to the S4148U-ON switch only. Skip this section if using other switches.

This section configures unified ports on S4148U-ON switches to Ethernet ports. Refer to the switch user's

guide for further details. Port-group 1/1/1-1/1/6 refers to the first 24 SFP+ ports on the switch. Use the

following commands to convert these ports to Ethernet ports.

OS10# configure terminal

OS10(config)# port-group 1/1/<port-group-number>

OS10(conf-pg-1/1/1)# mode Eth 10g-4x

OS10(conf-pg-1/1/1)# exit

OS10(config)#

Repeat the prior steps for port-group 1/1/1 to 1/1/6.

Note: QSFP+ and QSFP28 ports are by default in Ethernet mode. They can be configured by configuring

port-group 1/1/7-1/1/10 using the prior commands. Refer to the S4148-ON switch user's guide for more

information.

2.5

OS10(config)# interface mgmt 1/1/1

OS10(conf-if-ma-1/1/1)# no ip address dhcp

OS10(conf-if-ma-1/1/1)# ip address <ipaddress>/<subnet>

OS10(conf-if-ma-1/1/1)# exit

OS10(config)#

8 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG3704