Entec Solar E-1000 Краткое руководство по эксплуатации - Страница 16

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Измерительные приборы Entec Solar E-1000. Entec Solar E-1000 17 страниц.

3. The value of the temperatura shown is not correct.

a. Make sure that there is communication between E-Sens and the E-1500 /

E-1000. For a proper communication the colour shown in the background of the

radiation has to be yellow or green.

b. Check that the sensor conﬁguration is properly set up. Select Settings ->

Sensor Settings, and check that the temperature mode selected is the one you

actually use (PT1000, IR Sens, Mod Ref) and with the proper conﬁguration. Check

the section 5.5.6.B of the manual.

c. If there is no communication, shut down and turn on the device. It may also be an

issue with the distance. Check again with both devices close together and make

sure the antennas are installed properly.

d. It may also be the case that several E-Sens and E-1500 / E-1000 are working

together in the same place. This may result in noise between the communications.

As a result, you should only use one E-Sens, despite working with several I-V

curve tracers at the same time.

e. In the situation that the error still persists, please contact with the technical

service.

4. After pressing the button to measure, the device beeps and does not show the

curve and buttons do not work on the screen.

a. Check just above the settings button if the E-Temp option is selected. Also check

if there is a message on the screen stating that the device made a measurement

and it is waiting for the temperature value of the E-Temp. If that is the case, the

device is in the standby mode and it is waiting for the E-Temp data to make the

extrapolation of the curve values to continue measuring. If you do not own an

E-Temp or you do not need to use it, you have to disable it inside the sensor

settings before starting to measure.

5. The device does not sabe the barcode scanner data inside the csv ﬁles, even if it is

shown on the device screen.

a. When you are going to make a measurement saving the barcode scanner data,

you have to use the scanner only when the device asks for it through a message on

the screen. Otherwise, if you use the scanner too soon, you will still see the code

on the screen but it will not be saved on the csv ﬁle as it will not be associated with

the measurement performed.

"Innovative technological developments for the solar photovoltaic industry"