EarthWay 2170-XL Инструкция по сборке Руководство - Страница 6
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Разбрасыватель EarthWay 2170-XL. EarthWay 2170-XL 10 страниц. Commercial broadcast spreader with side spread control
Печатать страницуAssembly and Operation Instructions
Take the shortest end of the PIVOT
Step 10:
ROD and insert into the SHUT-OFF PLATE. You
may have two holes, use the SHUT-OFF PLATE
hole towards the back of the spreader. Insert it
through the hole (downward) and then rotate 90
degrees so that end is turned parrellel as shown.
Through hole,
then rotate
X-SECTION SHUT
OFF PLATE
Locate the PIVOT ROD backet, insert
Step 11:
the other end of the PIVOT ROD through the back
of the PIVOT ROD BRACKET as shown (see
below).
Install HANDLE SHAFT to LOWER HANDLEs and PIVOT & BRACKET assembly as shown. Using 2" bolts and
Step 12:
locknuts. TIGHTEN BOLTS AND NUTS NOW.
Install flattened end of CONTROL ROD
Step 13:
in to LEVER on GAUGE as shown. Turn to lock in
place. Next push LEVER forward to setting "0".
Align CONTROL ROD with hole in PIVOT BRACKET,
pull LEVER backward to insert CONTROL ROD
through hole in PIVOT BRACKET.
Install (1) 1/4-20 regular nut (not a
Step 14:
locknut) on to CONTROL ROD as shown.
2170_M52164_RevJune2021
PAGE 6