EarthWay 2170T Tow Руководство по сборке и эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Разбрасыватель EarthWay 2170T Tow. EarthWay 2170T Tow 6 страниц. Broadcast spreader
Печатать страницу
Install impeller onto pinion shaft. Insert ⅛"x 1-1/4" cotter pin
3.
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out. Next insert
cross brace (smaller diameter without the cross hole) thru the Gearbox
Brace.
6.
Install lower handles onto axle to both sides as shown. Insert 2 ¼" bolt through second hole in lower handle and through first hole in
frame install locknut. DO NOT TIGHTEN. Now insert 1 ½" bolt through first hole in lower handle. Then through frame brace. NOTE:
Dimples on frame brace must be facing toward gear box as shown. Next into threaded connector in cross brace (smaller diameter without
the cross hole). DO NOT TIGHTEN.
Next insert 1 ½" bolt through other end of frame brace and through second hole in frame threaded connector in cross brace.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2
4.
Install gear box by inserting the pinion shaft into hole in
center of hoppers bottom. The word "FRONT" on the gearbox
must point toward the hitch.
Follow label instructions on the hopper.
5.
Install axle bearings to both lower handles.
NOTE: Notch on bearings and lower handles.
Bearings must go through flat side of lower handle.