EarthWay 2600A-Plus Estate Руководство по сборке и эксплуатации
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Разбрасыватель EarthWay 2600A-Plus Estate. EarthWay 2600A-Plus Estate 8 страниц. Broadcast spreader
Также для EarthWay 2600A-Plus Estate: Инструкции по монтажу и эксплуатации (5 страниц)
Печатать страницу
2600A-Plus Estate
Broadcast Spreader
ASSEMBLY and OPERATING INSTRUCTIONS
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER, PLEASE CONTACT US. THIS MODEL INCLUDES LIFETIME TECHNICAL
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: [email protected]
HELPFUL HINTS:
; Make sure the ARROW on the gear box points to the front of the spreader. The impeller must turn clockwise.
Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each
use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate.
Clean and dry your spreader thoroughly after each use. A coating of light spray oil on all metal parts will help
prevent corrosion, pay special attention to coating the inside of the steel tubing.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
1. Remove and identify all loose parts from carton.
Upper handles
Handle Shaft
Wheels
Impeller
3. Install gear box by inserting the pinion shaft into hole in center
of hoppers bottom. The ARROW on the gearbox must point to
FRONT of the hopper. Follow label instructions on hopper.
Remove agitator when
using Rock Salt to prevent
gearbox damage
REVIEW THE DIRECTIONS BEFORE ASSEMBLY
Gauge &
Linkage
Assembly
Control Rod
Frame
Gearbox
Lower
Handles
Axle
Warning
2. Position hopper as shown to the
right. Install Frame using (4) #10
x 1¼" Flat Head Phillips screws.
TIGHTEN THESE NOW
Arrow
#10 X 1-1/4"
Flat Head Screw
8-2016 Pt# 52215
PAGE 1