EarthWay EV-N-SPRED 2150 Руководство по сборке и эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Разбрасыватель EarthWay EV-N-SPRED 2150. EarthWay EV-N-SPRED 2150 6 страниц. 50 lb. commercial spreader with side spread control
Также для EarthWay EV-N-SPRED 2150: Руководство по сборке и эксплуатации (8 страниц), Инструкция по сборке Руководство (9 страниц)

13.

Install handle shaft to lower handles

and pivot & bracket assembly as shown.

Using 1/4-20 x 1-3/4" bolts and lock-

nuts.

IGHTEN BOLTS AND NUTS NOW

14.

Install (1) 1/4-20 regular nut (not a locknut) on to con-

trol rod as shown.

16.

Pull lever back to setting "30" as shown. Next push pivot &

bracket forward so that the shut off plate in the hopper is in the full

open position. REMEMBER SETTING "30" ON THE FLOW

CONTROL LEVER MUST PLACE THE SHUT-OFF PLATE

IN THE FULL OPEN POSITION TO BE PROPERLY CALI-

BRATED. Now tighten the nuts against the pivot bracket to pre-

vent change in calibration.

15.

Install flattened end of control rod in to lever on gauge as

shown. Turn to lock in place. Next push lever forward to setting

"0". Align control rod with hole in pivot bracket, pull lever

backward to insert control rod through hole in pivot bracket.

Now install 1/4-20 regular nut on to control rod.

DO NOT TIGHTEN NUTS YET.

17.

Insert agitator to pinion shaft on inside of hopper. Note:

Position of flat side of agitator. This pin should be installed as

shown.

PAGE 4