Miele T 1323C CONDENSER DRYER Техническая информация - Страница 3
Просмотреть онлайн или скачать pdf Техническая информация для Сушилка Miele T 1323C CONDENSER DRYER. Miele T 1323C CONDENSER DRYER 3 страницы. Large capacity vented dryers flat controls, stacked washer & dryer example combination
Также для Miele T 1323C CONDENSER DRYER: Руководство по эксплуатации (36 страниц), Размеры изделия (12 страниц), Техническая информация (3 страниц), Инструкции по установке (2 страниц)
Печатать страницу
Washer Stand Installation
•
Drain the unit, before laying it on its side.
•
Remove the shipping struts
•
Lay the washer on its right side. Be sure to lay the unit on a flat, soft underlay (i.e. carpet)
•
Remove the washers feet
•
Using the threaded studs and nuts provided (M10), screw 2 nuts midway onto each threaded stud.
•
Screw the threaded studs (M 10) into the washer and tighten them see Fig. 5.
•
Install a washer (10.2 x 32 x 2) on each threaded stud.
•
Fit the stand onto the studs.
•
Install a washer (10.5) on each threaded stud.
•
Screw a nut (M 10) on each threaded stud and tighten.
•
Stand the washer upright
•
Install the washer stand rear panel using the 4 Torx screws provided see Fig. 3.
•
Place the washer into its final position.
•
Insert the 2 rubber bushings into the side holes of the washer stand. Install a washer and nut on each
and tighten the nut see Fig.6.
Dryer Stand Installation
•
Drain the unit, before laying it on its side.
•
Lay the dryer on its right side. Be sure to lay the unit on a flat, soft underlay (i.e. carpet)
•
Remove the dryers feet
•
Using the threaded studs and nuts provided (M8), screw 2 nuts midway onto each threaded stud.
•
Screw the threaded studs (M 8) into the dryer and tighten them see Fig. 7.
•
Install a washer (8.5 x 30 x 2) on each threaded stud.
•
Fit the stand onto the studs.
•
Install a washer (8.4) on each threaded stud.
•
Screw a nut (M 8) on each threaded stud and tighten.
•
Stand the dryer upright
•
Install the dryer stand rear panel using the 4 Torx screws provided see Fig. 3.
•
Place the dryer into its final position being sure to line up the studs of the rubber bushings with the holes
on the dryer stand.
•
Once the stands are together and in their final positions install a washer and nut onto each stud and
tighten the nut see Fig.6.
•
Install the caps into the open holes on the sides of the washer and dryer stand see Fig. 8.
Leveling
Once the washer and dryer (with stands) are in their locations. Adjust the feet until the stands are level. Tighten
the counter nuts.
Installing the Drawers
•
Pull out the stand drawer rails as far as possible.
•
Place the drawer on the rails and close the drawer, see Fig. 2.
•
The drawer locks into position automatically when it is closed.
•
Open the drawer as far as possible then close it to check that it functions correctly