360 YIELD CENTER 360 Series Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Сельскохозяйственное оборудование 360 YIELD CENTER 360 Series. 360 YIELD CENTER 360 Series 2 страницы.

Печатать страницу

STEP 3 | INSTALL DISK & HOSE GUIDES

NOTE: The supplied 3/8" x 1" bolt installed in the Bandit pin

up hole is to be used as a "zero" setting and as a stop in case

of spring disengagement.

Insert 5/8" X 3" bolt through the disk. Insert bushing 7

(large side first) and hose guide assembly 8 (ear tab facing out).

Slide assembly into the lower hole on the bandit 9, aligning

the ear tab with corresponding upper hole 1 and secure

with lock nut.

Tighten with 15/16" socket and wrench.

Using a mallet, install provided dust caps over bolt heads.

Route application hose through hole in top of 360 BANDIT

frame 1.

Repeat for other side.

PAGE 2 | 360YIELDCENTER.COM

STEP 4 | REINSTALL CLOSING SYSTEM

Use long M12 bolts, washers, and nuts 7 to attach closing

system casting to the 360 BANDIT unit.

Torque bolts to 42.2 ft lbs. Ensure not to over tighten bolts.

Reinstall insecticide attachment, if present.

NOTES:

If the closing wheels were removed but you are not

installing the optional Chain Kit, reinstall the closing

wheels at this time.

If the optional Chain Kit is being installed, do not reinstall

the closing wheels.

If pinning up 360 BANDIT disks while running spiked closing

wheels, mount spiked closing wheels in rear most hole.

INSTALLATION INSTRUCTIONS

STEP 5 | ASSEMBLE PLUMBING

NOTE: If hoses are not fully seated in the push to connect,

they will leak. Hoses seat 7/8" of an inch deep or until you

hear a snap.

Install orifice plates 1 in the rubber grommets 1.

Assemble pluming components in the arrangement shown

above 1. The supplied push to connect adapter in the 360

BANDIT kit connects to 3/8" push to connect compatible hose.

Secure hoses to row unit with provided zip ties 1.

PLUMBING RECOMMENDATIONS:

To prevent excess fertilizer from dribbling out of the hoses

when product application is shut off, install one push to

connect polypropylene (Inlet x Outlet) 3/8" O.D. check valve

(not included) in the plumbing to each row prior to the 360

BANDIT orifices. Check valve is available at Dultmeier Sales

(Item #BUCV1103-P38).

A 50 mesh strainer (not included) can be used in the

complete plumbing system between tanks and 360

BANDIT to help prevent debris from blocking orifices.

INSTALLATION COMPLETE