Miele KM 370 G Руководство по эксплуатации - Страница 26
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Варочная панель Miele KM 370 G. Miele KM 370 G 32 страницы. Gas
Также для Miele KM 370 G: Руководство по установке (32 страниц), Руководство по эксплуатации (28 страниц), Руководство по эксплуатации (28 страниц), Руководство по эксплуатации (40 страниц)
Печатать страницу
Connection to services
Important
This appliance should be installed
with plenty of space on either side.
See Installation Instruction Booklet
before making the gas and electrical
connection.
Gas connection
Connection to the gas supply, or
conversion from one type of gas to
another should only be undertaken
by an approved and registered gas
installer in strict accordance with
local and national safety and
building regulations, (e.g. Corgi
registered in the U.K.) Every
appliance should have its own
isolating valve and test point.
Check with your local gas supplier
about the type of gas and its
calorific value, and compare this
information with the type of gas
quoted on the hob data plate.
The installer is responsible for
ensuring that the appliance
functions correctly when installed.
The gas installation must be made in
such a way that the isolating valve is
visible and easily accessible after
the appliance has been built in.
26
Depending on country, the hob is
supplied ready for connection to natural
gas or to liquid gas (refer to label on
the appliance).
Category EN 30:
United Kingdom:
GB II 2 H 3 + 20 mbar, 28-30/37 mbar.
Ireland:
IE II 2 H 3 + 20 mbar, 28-30/37 mbar.
Depending on country, a set of jets for
conversion to natural or liquid gas is
included with the hob.
Please contact your dealer or agent for
the appropriate conversion jets if
necessary.
Conversion to another type of gas is
described in the separate Installation
Instructions supplied with this hob.
A test for possible leakages must be
carried out after installation.
Safety regulations demand that a
pressure test nipple is installed near a
gas hob to allow an engineer to test the
pressure following servicing.