Dialight ProSite Floodlight UL 1598 Инструкции по установке и эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Инструкции по установке и эксплуатации для Заливающий свет Dialight ProSite Floodlight UL 1598. Dialight ProSite Floodlight UL 1598 10 страниц.

Печатать страницу

Slip Fitter Models: F1U******S****

All assembly pieces should be packed into

the box for installation. The slip fitter is

designed to be mounted over a 2" [51mm]

pole or 2.38" [60.5mm] max O.D. tenon.

1. Slide the pole base onto application pole

and feed source wire conductor through the

opening of the pole base.

Pole Base

Junction Base

2. Slightly tighten the set screws of the pole

base but do not torque yet.

3. Feed the source wire conductors into the

junction base mounted on the luminaire and

engage the junction base with the mounted

pole base.

9100FLM000900 REV E

Page 4 of 10

ProSite Floodlight for UL 1598/1598A

4. Engage the captive pivot 7/16 hex bolt of

the junction base into the pole base to

secure the luminaire, but do not yet torque as

to still allow the luminaire to tilt for light pattern

aiming.

Cover

5. Tilt and turn the luminaire to desired

position on the application pole to illuminate

the desired area.

6. Once the luminaire is at the desired

position, tighten the pivot hex bolt.

Torque: 11 ft-lbs [14.9 N-m]

7. Tighten the set screws of the pole base to

secure position on the application pole.

Thread locker is recommended.

Torque: 5 ft-lbs [6.8 N-m]

Opening/Closing the Luminaire

This luminaire has 2 lids, a driver enclosure lid

and front access lid. Both lids are retained by

captive bolts and offer a combination head

style for ease of entry. The front access lid is

used for wiring the luminaire for bracket

models while slip fitter models do not use the

front access lid.

Bracket and Mast Arm Models:

Loosen the 4x screws and remove the lid to

gain access to the terminal blocks for wiring.

When wiring is complete, reattach the lid,

and tighten screws back down.

Torque: 30 in-lbs [3.4 N-m]

4x Captive Bolts

NOTE: The lid is secured to the wiring box via

a lanyard; eliminating risk of dropping the lid

upon removal.

NOTE: The lid of the luminaire should be

oriented as shown above. The Dialight logo

should be aligned with the mounting bracket.

Dialight, 1501 Route 34 South, Farmingdale, NJ, USA 07727

Tel: +1 732 919 3119 Fax: +1 732 751 5778

F*U******(E/F/T)****