Allo.com CT200E Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Карта PCI Allo.com CT200E. Allo.com CT200E 12 страниц. Transcoding card
Печатать страницуTranscoding Card CT200E - User Manual
Asterisk compilation & Installation
For using Asterisk for your application, follow the steps below.
Download Asterisk version 1.4.43. Expand the downloaded file, compile and
install.
#wget
http://downloads.asterisk.org/pub/telephony/asterisk/re
leases/asterisk-1.4.43.tar.gz
# tar -zxvf asterisk-1.4.43.tar.gz
# cd asterisk-1.4.43/
# ./configure
# make
# make install
# make samples
Allo Transcoding Card Installation
1. Download the driver from allo web site depend on the OS architecture,
http://www.allo.com/firmware/transcoding/allo-transco-64bit-driver.tar
2. Copy the driver to /usr/src
3. Untar the file "tar xvf allo-transco-64bit-driver.tar"
4. Change the directory to allotc and run "./network install", this
will install Broadcom driver(tg3) and once the installation is over reboot
the machine to make the eth1 interface UP
Note: In some machines transcoding card eth interface may show as eth1 or eth2
depend upon the number of network cards present in the server. Allo Transcoding
card can be identified with MAC id "00:17:F7:XX:XX:XX"
5. After reboot run "./install.sh <asterisk source path>"
from the same directory
Note: If the asterisk source directory is not provided for ex: "./install" the
process will continue with Trix-Box/Elastix Installation.
Operating Systems Other than Trix-Box/Elastix should mention the asterisk
source
as
said.
for OpenSuse use "./open_suse_install <asterisk source path>"
6. The script will prompt you to enter the transcoding card based on the
MAC address
E.g.: CHOOSE THE ETERNET DRIVER IN WHICH YOU HAVE HWaddr
00:17:F7:00:00:00 Eg: If transcoding card interface is eth2 select "2"
7. The script will prompt you to configure ip address for transcoding card,
configure IP address different from your network.
E.g.: CHOOSE DIFFERENT IP OTHER THAN YOUR NETWORK FOR TRANSCODING
CARD Eg: 10.1.1.1:
8. Script will prompt you to select the transcoding card depending upon
the MAC id (00:17:F7:XX:XX:XX)
E.g.: Please select device to configure: [1-1] q: quit 1
Version: 1.0
For
E.g.:
"./install.sh
/usr/src/asterisk-1.x.x."
and
Page 6